APL 1A Low Dropout Fast Response Positive Adjustable Regulator and Fixed V, V and V. Features. Guaranteed Output Voltage Accuracy within. APLVC-TU 1A Low Dropout Fast Response Positive Regulator Fixed V and V 1A, Details, datasheet, quote on part number: APLVC-TU. APLUC-TU from Anpec Electronics Corp.. Find the PDF Datasheet, Specifications and Distributor Information.
|Country:||Sao Tome and Principe|
|Published (Last):||22 January 2006|
|PDF File Size:||3.56 Mb|
|ePub File Size:||14.58 Mb|
|Price:||Free* [*Free Regsitration Required]|
When the adjustable regulator is used. The data sheet speci.
Best load regulation is obtained. For fixed voltage devices the top of R1 is internally.
This will improve transient response as well as pro. By plac- ing a resistor between these two terminals, a con- stant Current is caused to flow through R1 and down through R2 to set the overall output voltage.
APL Datasheet(PDF) – Anpec Electronics Coropration
Normally this current is chosen to be the vatasheet minimum load current of 10mA. For fixed voltage devices R1 and R2 are included in the device. Tantalum, or aluminum electrolytic capacitors can be used for bypassing. Basic Adjustable Regulator ues will improve ripple rejection by bypassing the in- put to the regulator.
Load Regulation When the adjustable regulator is used. Load regula- tion will be limited by the resistance of the wire con- necting the regulator to the load.
APL datasheet, APL datasheets, manuals for APL electornic semiconductor part
The data sheet speci- fication for load regulation is measured at the output pin of the device. Best load regulation is obtained when the top of the resistor divider R1 is tied di- rectly to the output pin of the device, not to the load.
For fixed voltage devices the top of R1 is internally connected to the output, and the ground pin can be connected to low side of the load.
If R1 were con- nected to the load, RP is multiplied by the divider ratio, the effective resistance between the regulator and the load would be: Proper capacitor selection is important to ensure proper operation.
Результаты поиска для APL1117-AH
The APL output capacitor selection is dependent upon the ESR equivalent series resistance of the output capacitor to maintain stability.
This will improve transient response as well as pro- mote stability.
A low-ESR solid tantalum capacitor works extremely well and provides good transient re- sponse and stability over temperature. Home – IC Supply – Link.