Contents. Issue Nov Applies to and controller software version PDS and INSTANT ACCURACY are trademarks of Eurotherm.” Issue The / is a versatile, high stability temperature or process controller, with self and adaptive tuning, in including: Modbus®, Eurotherm Bisync, and SPI. The 1/8 DIN unit is a controller with an extensive range of options. Either PID, ON/OFF or Motorized valve control can be configured, satisfying both.
|Published (Last):||12 July 2005|
|PDF File Size:||1.52 Mb|
|ePub File Size:||9.73 Mb|
|Price:||Free* [*Free Regsitration Required]|
Chris Mooney Official Rep. Log in or Sign up. Community-powered support for Eurotherm. Overview Topics Products People Change log.
Eurotherm Temperature Process Controller | eBay
Help get this topic noticed by sharing it on Twitter, Facebook, or email. Jan Pischel April 17, It is impossible to change the ‘StAt’ parameter in ‘run LiSt’ to ‘run’ although it is set as ‘ALtr’ the device has only one program available which I have set up to have four segments.
Is there a parameter which I have to enable first in order to be able to run programs at all? Chris Mooney Official Rep April 17, If this parameter is set to anything other than OFF, you will not be able to start your program. Please check this and let me know how it turns out.
Not a problem Acknowledged In progress Solved. Regards, Chris How does this make you feel?
Eurotherm 2408 Temperature Process Controller
Hello Chris, thank you for your prompt reply! I checked the SPrr parameter and found it to be set to ‘off’, so this cannot be the problem. May eurrotherm there are other possible reasons?
Best regards, Jan How does this make you feel? Jon Official Rep April 17, Hello Jan, Do you have the full model code of the controller?
Regards, Jon How does this make you feel? How does this make you feel? There are a couple other things that can stop the program running: As basic a question as this might be, but are you able to control the process without running a program?
Can you set a setpoint from the front panel and the controller will accurately control to that temperature? Thank you for your help! Actually, I tried to start the program in manual control mode.
Starting it from auto control mode worked for me. I feel, a corresponding hint is missing in the user’s manual at least I missed it. Charles Bureau June 26, Jan Pischel June 27, For me, the problem was really that the Eurotherm was in manual mode.
As I wrote above, starting the program in auto control mode worked for me. Cheers, Jan How does this make you feel? Ito G May 10, The has a way to us the program 1 program ptyp 1 enable with 8 segment each program If you want to have many programs with 16 segment each then yo need to get the firmware upgrade to do that.
When ordering the controller mention that you want multiple programs with up to 16 segments each segment are the steps you program will do like: Wdell, ramp-up, step down, repeat cycle.
Eurotherm should have a table where we can check for our controller capabilities. If they do, I don’t know where it can be. Also, I called the lots of times but “no credit card, not answer” They should post more about with “ins” and “outs” so we can know what we can do or not.
If Eurothermo is ignoring you here is one good manual. Anton Lefering July 29, Although this seems to me non-obvious and pretty essential information I could not find it in the documentation.